Thank you for the links.
The 1st one is from Mark. I know him very well. I’m using his jets, and my 1st board is based on his work.
We are at this moment in the process of shaping the EPS foam (the blank) to what we thing is a good “jetboard” design. (again… what we think)
Basically the max width of the board will be more to the back. It will be 12cm thick, and have a “V” bottom with a little bit of concave in it for speed. The length will be 170cm.
Rails will be “hard” (sharp) to make the board bite in turns (for carving).
Shape will be a cross between the Radinn freeride and carve model.
Will post some photo’s here in time.